Nokta - Makro Pulsedive Pointer + Scuba SET

Categories: Nokta - Reviews and tests , Detektory Nokta Pulse Dive

I would like to start by saying that I was really looking forward to completing this project. Up until now, there was basically nothing else for searching in the sea with a snorkel in your mouth but detectors from Treasure Product and they didn't quite meet my idea of how such a device should work. But the Pulsdive seems to be something completely different from the start and we take it 100% for snorkeling to the sea. :-)

Video

Description of the setup

Charging the detector.

Red and green simultaneously - the device is fully charged and can be disconnected from charging
note: The device cannot be used whilecharging.

Checking the battery after switching on the device: immediately after switching on the device, the battery capacity can be checked by means of several status LEDs.
1. red and green LEDs flash simultaneously - the battery has full capacity
2. Green LED flashes - the battery is at 50% capacity
3. Red LED flashes - the battery is empty

If the batteries are absolutely flat the red and green LEDs will flash every 5 seconds. You will be able to work with the detector for a short time, but then it will beep and shut down.

Basic settings

Switching on/off and calibrating the instrument

Press the ON/OFF button briefly to turn on the PULSE DIVE and a short tone will be heard to announce that it has been turned on.
The initial calibration of the instrument will happen automatically as soon as the instrument is turned on.
At any time during use, the PULSE DIVE can then be recalibrated (reset) by briefly pressing the ON/OFF button.
To turn the instrument off, long press the ON/OFF button and you will hear the instrument shutdown tone.

WARNING: If the detector is in DIVE MODE it will not respond to any button presses! Setting the

search modes

There are a total of 3 search modes: audio / vibration / audio+vibration.
To set the desired mode, turn on the detector and use the short press of the F button to select the desired mode. All detector settings will remain saved even after the unit is switched off.

Sensitivity settings

The PULSE DIVE has a total of 5 sensitivity settings. The settings are made on the instrument when it is switched on using the F and A buttons. The number of beeps or vibrations (depending on the selected mode) during sensitivity adjustment corresponds to the selected sensitivity of the instrument (1-4), reaching the maximum sensitivity (5) is indicated by a long beep or vibration.

Extension settings

Switching the backlight on and off: By briefly pressing the A button, the LED backlight can be switched on or off.
DIVE MODE: This mode is designed for divers who wish to use the PULSE DIVE at greater depths where there is a risk of the buttons being pressed spontaneously due to water pressure. In this mode, the detector will not respond to any button presses, so turn this mode on only when you have the detector set up to your liking.

To activate the dive mode, rotate the detector 180 degrees along the horizontal axis (i.e. :the signal LEDs must point downwards towards the ground). In this position, press and hold the A and F buttons simultaneously and do not release until you hear a long tone or feel a vibration. In this mode, the detector does not respond to any button presses or metal objects when the signal LEDs are turned downward. The detector is off but in standby mode. The detector will only react to metal objects in the probe down position.

Operating Frequency Shift (FREQ. SHIFT): The FREQ. SHIFT, which contains a total of 40 working channels.
To set the working channel, press and hold the F button. Now you can select the individual working channels by simultaneously pressing the ON/OFF button briefly. The switching of the individual channels will be announced by a short beep or vibration. The factory set channel is in the middle of the 40 channels and will be indicated by a double beep or vibration.

Using the detector underwater and on land

The detector package includes two different types of rear screw-on charging caps.
The included 4-hole cap is for use on land. All of these cap holes are fitted with a fabric membrane to allow better sound propagation from the speaker, while protecting the PULSE DIVE from dirt entering the charging connector and the interior of the electronics.

WITH THIS COVER, THE DETECTOR CANNOT BE IMMERSED IN WATER AS THERE IS A RISK OF WATER RUNNING INTO THE DETECTOR AND CONSEQUENTLY DAMAGING THE ELECTRONICS. If you want to use the PULSE DIVE underwater, you must use the enclosed cap.

Technical data

Whether you are a classic searcher or a diver, this pinpointer simply has to excite you as much as it excites us. The PulseDive set includes both a finder and a coil to use when diving. The entire detector is waterproof to a depth of 60 meters. Of course, it can be used on land as a classic tracker, but also in salt and normal water.

Patented design - This innovative design allows the tracking device to be quickly transformed into a diving detector in a matter of seconds.

IP68 - Waterproof to 60 meters.

Pulse Induction Technology - Allows stable operation in salt water as well as in all types of soil.


Built-in wireless module - Compatible with Nokta Makro 2.4GHz Green Edition wireless headsets.


Detection Types - 1. Audio only, 2. Vibration only, 3. Audio and vibration
In addition to all modes indication by LED.


LED Flashlight - For working underwater and in low light conditions.


Rapid Retune - Ensures stable operation at the push of a button.

Dive Mode - Provides easier operation underwater by locking the keys and preventing them from being compressed by water pressure during deep diving.


Loss Alarm - After 5 minutes of inactivity, the unit sounds an audible alarm and the LED starts flashing.


Hard-Shell- A protective case that prevents wear and tear.

Catalogue sheets

Nokta Makro PulseDive SET - Package and Specifications

  • Durable carrying case
  • Probe designed for searching in water (circular, waterproof)
  • Cover for circular probe and finder
  • Belt pouch
  • Safety lanyard
  • Dust cap
  • USB charging cable

Technical Specifications

  • Technology.
  • Working frequency: 3 kHz
  • Working frequency shift
  • Waterproof up to 60 m
  • Integrated wireless module (can be connected to Nokta Green Edition headphones)
  • Operating modes - Audio / Vibration / Audio + Vibration - all combined with LED
  • Adjustable sensitivity - 5 levels
  • Power supply - integrated 1650 mAh Li-Po battery
  • Dimensions and weight - Scuba 39 cm / 419 g (including caps), Tracking 28 cm / 286 g (including caps).
  • Warranty 2 years

Prices and package contents

Nokta - Makro Pulsdive Pointer + Scuba Yellow SET

Price 4.890 CZK incl. VAT

Nokta - Makro Pulsdive Pointer + Scuba Black SET

Price 4.890 CZK incl. VAT

Nokta - Makro Pulsdive Pointer

Price 3.290 CZK incl. VAT

The article is included in categories:

Post

Neruší sa s Equinoxom keď sa to bude použivať ako dohladavačka na sucho alebo sa to dá odladiť ? dik

Ahoj, obecně se pulzní detektory s multifrekvenčními moc nemusí.Jelikož multifrekvenční detektory nemají na vysílací sondě sinus ale mírně skosený obdelník, tak se to pulzákům moc nelíbí.
Obecně bych v kombinaci detektor -dohledávačka doporučil se držet výrobce , jednak máte jistotu že se oba detektory budou kamarádit a i do budoucna kdyby jste vyměnili detektor nebo dohledávačku za novější model tak máte jistotu že se budou kamarádit.

Pokud počasi dovolí, uděláme brzy první video pod vodou ;-)

Super. Ale dotaz, kdy budou ty slíbená videa na Kruzera? Děkujííí.

Poki77: ano, do konce příštího týdne včetně teréního testu ;-)

No uvažuji o něm a to dost vážně.

Jednoznačně s námi jede na dovolenou. Jsem zvědavý jak to se šnorchlem půjde :-)

Mám zkušenost,že kde jsou větší vlny a člověk šnorchluje tak když chytne signál tak je problém ho dohledat jak s nim ty vlny házej :-D.Na klidný vodě to je ok ale třeba ve Španělsku to byl masakr.Chytl jsem signál a než jsem ho vydoloval co to je byl jsem někde jinde :-)

Zdarec ještě by bylo dobré ukázat jak lze dohledávačku spárovat se sluchátky. V návodu žádný návod jak to provést. Mě se to osobně nedaří. Předem děkuji.

Hoplop-video jsme tocili hned jak prisla a zrovna jsem nemel po ruce sluchatka,kazdopadne nokta poslala nejake instrukce protoze v navodu je to popsano dost stroze,az se dostanu v pondeli/utery do kanclu tak zkusime lepe natocit dosahy s metrem a vyzkousime to parovani.

Zdarec, díky už se nemohu dočkat. ;-)

Zdravim, včera jj sem se s detektorem potápěl a super mince jsem tahal dost a úspěšně. Dnes mi prijde že náma vůbec dosah na souši to bere skoro až u sondy. Zkoušel jsem nastavovat citlivost ale je to marný.. jde nějak udělat tovární nastavení. Je možný že se mi to zdá.. díky

Add post

You must subscribe to post. If you do not have an account on this site yet, sign up.

↑ Back to top + See more

Back to top