Helikon-Tex® AeroTech® men's tactical trekking trousers

TTP - Trekking Tactical Pants are lightweight, outdoor trousers, made of special lightweight polyester materialAeroTech®, which is also very breathable and quick-drying, designed for the summer months. These are multi-purpose trousers that will prove useful for both outdoor work and adventure trips, from light hiking to alpine trekking to cycling or a trip to the shooting range.

The minimalist design and comfortable fit allows the trousers to be taken into town as well as for more challenging off-road activities.

Long legs with tunnels where you can thread the drawstrings and tighten the trousers around the ankles and reinforce theThe reinforced knees with internal pockets for inserting knee pads ensure safety in a variety of terrain.

The trousers feature a total of six pockets - two front slanted hand pockets with a reinforced edge, two standard slanted pockets in the back and two straight pockets in the back for your smartphone, batteries and other gear.

An elastic waistband adjustable with Velcro with a raised back waistband increases comfort during activities that require frequent position changes. Two loops for carabiners or D-rings are also handy.

SIZE AND CUT CHART

SIZING INSTRUCTIONS

We want to make sure that the clothes you buy actually fit you - that they serve their purpose correctly. Please take a moment of your valuable time to review the measurement guide and corresponding size chart to avoid mistakes.

To take the right measurements, find clothes that fit you well and measure them.

Chest - Button your clothes and lay them on a flat surface. Measure from the left edge to the right edge just below the sleeves.

Waist - Button the garment and lay it on a flat surface. Measure from the left edge to the right edge at the waist.

Sleeve length - With the shirt you like, measure with the arm at your side from the shoulder seam along the entire arm until you find the length you want. It is recommended that the sleeve point towards the root of the thumb (located at the wrist).

For jackets with raglan sleeves, such as Stratus® or Cumulus®, the sleeves should be measured from the bottom of the collar to the sleeve cuff.

Inner - seam Fasten trousers. Lay the trousers on a flat surface. Measure the distance of the inseam from the crotch, where the front and back seams meet, to the bottom of the legs.

Trouser length - Fasten the trousers. Lay the trousers on a flat surface with the outer seams on both edges. Be careful to pull all wrinkles and fullness out of the back panel. Measure the distance from the top of the waistband to the bottom of the hem.

THE TOLERANCE OF THE MEASUREMENTS GIVEN IN THE TABLE IS +/- 2 CM (APPLIES TO GARMENTS ONLY).