Men's Helikon-Tex® MCDU combat trousers - DYNYCO

The MCDU (Modern Combat Duty Uniform) trousers are Helikon-Tex's answer to the demand for a modern combat uniform that is as comfortable as possible and functional under all conditions.

For the MCDU trousers, the company has for the first time used DyNyCo as the base material, a material that is exceptional in that it is flexible in four directions. It has strength parameters similar to standard NyCo, but also contains elastic fibres.

In stressed areas (waist, crotch, back of knees), the cut of the trousers is reinforced with VersaStretch, which dries quickly and is highly breathable. The front part of the knees is reinforced with a special Cordura 500D fabric and has holes for protective inserts. Drawstrings located below the knees and at the bottom of the legs ensure that you can quickly and easily adjust the trousers to your needs.

The look of the trousers is inspired by the Polish paratrooper uniforms of the 1950s. The trousers have a total of 12 pockets to hold everything you need.

Century. A total of 12 pockets allow you to organize your gear. This solution makes the trousers even more functional, especially on warm days or during long walks.

SIZE AND CUT CHART

SIZING INSTRUCTIONS

We want to ensure that the clothes you buy actually fit you - that they serve their purpose correctly. Please take a moment of your valuable time to review the measurement guide and corresponding size chart to avoid mistakes.

To take the right measurements, find clothes that fit you well and measure them.

Chest - Button your clothes and lay them on a flat surface. Measure from the left edge to the right edge just below the sleeves.

Waist - Button the garment and lay it on a flat surface. Measure from the left edge to the right edge at the waist.

Sleeve length - With the shirt you like, measure with the arm at your side from the shoulder seam along the entire arm until you find the length you want. It is recommended that the sleeve point towards the root of the thumb (located at the wrist).

For jackets with raglan sleeves, such as Stratus® or Cumulus®, the sleeves should be measured from the bottom of the collar to the sleeve cuff.

Inseam - Button the trousers. Lay the trousers on a flat surface. Measure the distance of the inseam from the crotch, where the front and back seams meet, to the bottom of the legs.

Trouser length - Fasten the trousers. Lay the trousers on a flat surface with the outer seams on both edges. Be careful to pull all wrinkles and fullness out of the back panel. Measure the distance from the top of the waistband to the bottom of the hem.

THE TOLERANCE OF THE MEASUREMENTS GIVEN IN THE TABLE IS +/- 2 CM (APPLIES TO GARMENTS ONLY).