Men's Helikon-Tex® Blizzard StormStretch® Pants

Softshell pants Blizzard StormStretch from the Polish manufacturer Helikon-Tex are part of the model series Outback. It is a modern, versatile all-weather clothing, especially suitable for outdoor and mountain hiking. The hybrid construction composed of StormStretch® and VersaStretch® stretch materials provides durability and maximum comfort even when worn for long periods of time. The fabrics used and the gusset in the crotch allow great freedom of movement and adaptation to running, kneeling and the like. For added water resistance, the pants have a Teflon DuPont water repellent finish. The lower leg is reinforced, and there is a drawstring at the bottom hem of the pants and a hook for attaching the pants to the shoe laces.

The trousers have a small sewn-in belt at the waist. However, there are also enough loops around the perimeter to stretch a classic belt up to 50 mm wide.

On the front there are two classic hand pockets with a reinforced hem on which you can hang a pocket knife, pen or flashlight by a clip. In addition, the trousers have two back pockets and two side pockets on the thighs, which are closed with YKK zippers and have a small pocket inside for small items. Behind them there are zipped openings for ventilation.

The Blizzard trousers are oversized, which should be taken into consideration when purchasing. This makes them the perfect second (outer) layer.

SIZE AND CUT CHART

SIZING INSTRUCTIONS

We want to make sure that the clothes you purchase actually fit you - that they serve their purpose correctly. Please take a moment of your valuable time to review the measurement guide and corresponding size chart to avoid mistakes.

To take the right measurements, find clothes that fit you well and measure them.

Chest - Button your clothes and lay them on a flat surface. Measure from the left edge to the right edge just below the sleeves.

Waist - Button the garment and lay it on a flat surface. Measure from the left edge to the right edge at the waist.

Sleeve length - With the shirt you like, measure with the arm at your side from the shoulder seam along the entire arm until you find the length you want. It is recommended that the sleeve point towards the root of the thumb (located at the wrist).

For jackets with raglan sleeves, such as Stratus® or Cumulus®, the sleeves should be measured from the bottom of the collar down to the sleeve cuff.

Inner - seam Fasten trousers. Lay the trousers on a flat surface. Measure the distance of the inseam from the crotch, where the front and back seams meet, to the bottom of the legs.

Trouser length - Fasten the trousers. Lay the trousers on a flat surface with the outer seams on both edges. Be careful to pull all wrinkles and fullness out of the back panel. Measure the distance from the top of the waistband to the bottom of the hem.

THE TOLERANCE OF THE MEASUREMENTS GIVEN IN THE TABLE IS +/- 2 CM (APPLIES TO GARMENTS ONLY).