Men's tactical trousers Helikon-Tex® UTP® PolyCotton Ripstop

What makes the UTP - Urban Tactical Pants® from the UTL - Urban Tactical Line so special? The anatomical fit and pocket layout used in these pants provide a sufficiently civilian look and feel to provide aThe trousers maintain full functionality for both military and tactical use, as well as for a variety of outdoor activities. A wide elastic band is inserted in the back of the waistband and, combined with the Velcro strap, allows for comfortable girth adjustment. The wide belt loops can accommodate up to a 50mm wide belt, including all HTX tactical belts: EDC, UTL® or Cobras®. In addition, the cut used, typical of classic jeans, has reduced the tendency of the pants to ride up when worn. The flap is fitted with a high quality YKK branded zipper, plus Velcro.

The trousers are made of fabric with special RipStop treatment, thanks to which they have increased resistance to punctures and tears, respectively. The ripstops are more resistant to tearing and further expansion if a tear does occur.

The trousers offer a number of pockets, judiciously arranged for storing all the necessary equipment. The edges of the front and back pockets are reinforced, for increased abrasion resistance when carrying clip-on equipment (writing pen, multitool, closing knife, etc.). The other two front pockets with Velcro flap closure are large enough to fit a smartphone or even an AR/AK rifle magazine. The zippered thigh pockets look flat - but their design makes it easy to carry bags or wallets. Two interior pockets with storage to adjust volume for concealed carry magazines, etc. Tailored insert pockets on the knees await filling with low-profile protectors.

Belt not included.

SIZE AND CUT CHART

SIZING INSTRUCTIONS

We want to ensure that the clothes you purchase actually fit you - that they perform their purpose correctly. Please take a moment of your valuable time to review the measurement guide and corresponding size chart to avoid mistakes.

To take the right measurements, find clothes that fit you well and measure them.

Chest - Button your clothes and lay them on a flat surface. Measure from the left edge to the right edge just below the sleeves.

Waist - Button the garment and lay it on a flat surface. Measure from the left edge to the right edge at the waist.

Sleeve length - With the shirt you like, measure with the arm at your side from the shoulder seam along the entire arm until you find the length you want. It is recommended that the sleeve point towards the root of the thumb (located at the wrist).

For jackets with raglan sleeves, such as Stratus® or Cumulus®, the sleeves should be measured from the bottom of the collar down to the sleeve cuff.

Inner - seam Fasten trousers. Lay the trousers on a flat surface. Measure the distance of the inseam from the crotch, where the front and back seams meet, to the bottom of the legs.

Trouser length - Fasten the trousers. Lay the trousers on a flat surface with the outer seams on both edges. Be careful to pull all wrinkles and fullness out of the back panel. Measure the distance from the top of the waistband to the bottom of the hem.

THE TOLERANCE OF THE MEASUREMENTS GIVEN IN THE TABLE IS +/- 2 CM (APPLIES TO GARMENTS ONLY).